Engine Harness Modification

[Paparazzi]

Hi Guys,

I have spent numerous days searching for the answer so I didn't waste anyone's time, however the answers I have found do not point directly to my needs. Please excuse me if I am missing something or have passed over a helpful thread.

I am curious about engine harness modification, specifically deleting all unnecessary items from the harness. I have seen this touched on in many people's threads but never openly addressed straight forward. I am doing a swap, I purchased both tranny and engine harness from wiring specialties to get my RB swap rolling. BUT, I want to address the front harness (that includes the engine fuse box, lights, and runs along the driver side inner fender to the floor area of the driver side foot well.) As well as a more general question for any harness modification.

I no longer have washer fluid reservoir, AC, heating, radio, or speakers in the vehicle, and I want these wires out. I am meticulous and can pull each wire at a time correctly, I just want to know if say I trace all the AC wires around the car and remove all of them, speaker wires, etc. will I run into issues? What is the proper method of modifying or deleting items from a harness, just snip at the clip/plug and seal closed?

Again I appreciate any help and direct answers to harness modification, or a point in the right direction.