Bee R rev limiter on SR20 help!

[Jersthecool]

So I bought this thing a while back and never did get it working. Could never get the right wires or anything but now I'm so close but so far from getting it. So I got the right ground and power wires then I hooked up the yellow to the CAS 180 degrees and the green wire to the CAS 1 degree, start the car, change the rev 1 and gain and nothing happens just acts like it's not installed and there's no lights or anything. So I switch the green and yellow wires around, start the car, move the knobs and as soon as I touch the gain knob right away the car dies. If you try to start it then it won't start back up will just keep cranking until the gain is set back to 0 which turns the unit off then right away it will start back up until you touch the gain again.

Anyone have a clue what is going on? Am I connecting it to the right wires or is there another sort of problem somewhere?


According to this diagram I currently have the:
Ground - pin 48
Power - pin 47
Yellow - switching between 22 and 31 and have also tried using 30 and 40
Green - switching between 22 and 31 and have also tried using 30 and 40