Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Tech Talk

Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-14-2005, 06:56 AM   #9
PROJECTRB240SX
Zilvia Junkie
 
Join Date: Dec 2003
Location: GILBERT, AZ
Posts: 304
Trader Rating: (0)
PROJECTRB240SX is an unknown quantity at this point
Feedback Score: 0 reviews
Those Are The Three Common Locations For Grounds On A Vehicle. Neg Battery Post, Engine Block, And Frame Rail (or Other Chassis Location). The Only Time Your Alternator Should Have A Complete Circuit (power Through The Alternator To Ground) Is When You Turn The Key On. It Sounds Like You Have A Crossed Wire, Shorted Wire, Or Possibly A Bad Alternator. I Would Check The Wire The Connect To The Alternator To Rule Them Out Then I'd Swap The Alternator Out. Is This In An Engine Swap? If It Is Did You Use The Swapped Engines Lower Harness Or Adapt The Ka Harness? If You Used The Ka Harness Besure You Didn't Mix Two Wires Up, If You Used The Engines Original Harness Make Sure You Used The Proper Connections At The Fuse Box.
__________________
IF I AM TYPING IN CAPS (LIKE NOW) I AM SORRY BECAUSE I AM AT WORK (DATA ENTRY) AND I HAVE NO CAPS LOCK BUTTON AND NO WAY TO CHANGE MY UPPER CASE LETTERING. SORRY!
PROJECTRB240SX is offline   Reply With Quote
 

Bookmarks


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 05:18 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net