solid mounted exhaust question - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

zoototheyork · 02-24-2008, 01:17 PM

only doing this because the greddy ti-c sits so dam low! its not the rubber mounts or car, it came shitty.

idea is to weld two thick steel tabs to pipe with gussets. bolt to rear subframe. i tacked on a tab and bolted it up. the exhaust was 3 inches higher with no-clearance problems. or take more time cut/bend existing hangers? no flex pipe. so that sucks too, any input ?

02-24-2008, 01:17 PM	#1
zoototheyork BANNED Join Date: Sep 2006 Location: dover, nj and orlando, fl Age: 38 Posts: 189 Trader Rating: (0) Feedback Score: 0 reviews	solid mounted exhaust question only doing this because the greddy ti-c sits so dam low! its not the rubber mounts or car, it came shitty. idea is to weld two thick steel tabs to pipe with gussets. bolt to rear subframe. i tacked on a tab and bolted it up. the exhaust was 3 inches higher with no-clearance problems. or take more time cut/bend existing hangers? no flex pipe. so that sucks too, any input ?