450sx part 2

[gsracer]

Yes Im going to run dual exhaust but out to the stock location pics below.


For the ps the hose you see is regular teflon braided hose, summit racing sells this stuff, this is only for the low pressure return side, for the high pressure im getting one made although the stock 240sx hose would probably work.

Got the preliminary cutting and flanges welded on the xpipe. Got to go pick up my mufflers and the rest of the mandrel bends i need to finish this tommorow.







Here it is installed on the car.







As you can see there is no illusion of grond clearance here, my car is pretty low ( as low as the tein coilovers will go) and i have about 3 and some change inches of ground clearance. It should be fine as the other one hung about as low and only became an issue on some speed bumps and going on and off the trailer. Besides it aint any lower than the headers