MAF problem (stumpted) - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

SE-R Spec · 07-19-2009, 09:30 AM

whats up guys.

alright so i just did the sr swap into my 92 S13. everything is wired corectly according to the diagrams

go to start the car and it starts but sputters and dies. after a while we narrowed it down to the MAF being the problem.

if you cover the MAF with your hand, restricting the amount of air going in, the car will run, rev, blow off, everything fine which baffles me.

i have tried to move the MAF farther away from the turbo inlet but nothing changed. i am currently using the stock rubber tube and the intake with the MAF at teh end near the front of the fender on the driver side.

can anybody suggest something other than getting a new MAF? i have 2 KA MAFs and 1 SR MAF that i have tried with all the same results. i am pretty sure that all 3 of those are not FUBAR'd

derek

07-19-2009, 09:30 AM	#1
SE-R Spec Join Date: Jul 2009 Location: West Virginia Age: 34 Posts: 10 Trader Rating: (0) Feedback Score: 0 reviews	MAF problem (stumpted) NOW WITH VIDEO whats up guys. alright so i just did the sr swap into my 92 S13. everything is wired corectly according to the diagrams go to start the car and it starts but sputters and dies. after a while we narrowed it down to the MAF being the problem. if you cover the MAF with your hand, restricting the amount of air going in, the car will run, rev, blow off, everything fine which baffles me. i have tried to move the MAF farther away from the turbo inlet but nothing changed. i am currently using the stock rubber tube and the intake with the MAF at teh end near the front of the fender on the driver side. can anybody suggest something other than getting a new MAF? i have 2 KA MAFs and 1 SR MAF that i have tried with all the same results. i am pretty sure that all 3 of those are not FUBAR'd derek Last edited by SE-R Spec; 07-20-2009 at 12:57 PM..