Power Steering+AN Lines + Cooler=Good times!

[japslapsilvia]

So ive had some members PM me about my PowerSteering Setup. so i figured i would post a quick how to.

Rack Return 16x1.5 O ringed to -6AN 991955ERL
Rack High Pressure 14x1.5 O-ringed -6AN 991954ERL
Pump High Pressure 16x1.5 Crush Washer -6AN 9919DFJERL


For the line I bought 2 feet…only used about 1.5 feet or so.. of 130006ERL Power steering hose.
and 2 of theses 139106ERL 90* -6AN hose ends for Power steering hose.



For the cooler I got a small cooler off ebay with -6AN inlet and outlet.



You will also need
1 -6AN weld on fitting
2-10AN weld on fittings




Then I decided to be a little cheap and used Summit Racing Push Lok hose and fittings so I got
3 feet of -10AN (5/8ths ID) hose
6 feet of -6 AN (3/8ths ID) hose
2 Straight -10AN push lock fittings
4 90* -6AN push lock fittings

I took the resivor off and had the -6 fitting welded to it (return side, side of the resivor) and the -10 fitting welded on as well (feed side, the bottom of the resivor)



It should be noted that there is a small filter inside the reservoir I didn’t notice it and it melted

Then I took the feed fitting off the pump and had the other -10AN fitting welded to it.





so the way the system works it as follows….resivor Ã*10line Ã*pump Ã* -6 high pressure P/S line Ã* rack Ã* -6 pushlock hose Ã* P/S cooler Ã* resivor.

All the Earls fittings I used came from ANplumbing.com

And push lock hose and fittings came from SummitRacing.com

Curently i dont have my Cooler mounted yet as i have to find a proper location for it.

THANKS!!!