Matts13vert's Socal Dream (Super Stock) KA-T Setup. SR exhaust manifold used!

[matts13vert]

2014-08-04: FORWARD TO PAGE 7 FOR UPDATED SETUP.



☆ ------------------ ☆ ------------------ ☆

A few months ago, I decided to turbo my KA, but only if I can get it to look as factory as possible, so no shiny piping or flashy parts. I wanted this to look 100% STOCK. Luckily, a guy on Craigslist was selling some turbo parts from an SR, so I swooped them up on my way to Formula D (Beginning of October 2010). It took me about two months to find and buy all the parts, then the build started (Beginning of December 2010).

All the parts used:
-T25 Turbo
-SR Manifold modified to be used on a KA with Stock SR Heat Shield
-370cc Injectors
-SMIC w/ Intercooler Piping and OEM air duct
-Greddy 3" Elbow
-3" Down Pipe
-S14 Upper Intake Manifold with plugged PCV Ports
-PCV system modified using one check valve, tee, and oil separator
-NISSPORT Oil Pressure Adapter
-Mishimoto Radiator with Dual Electric Fans (painted black)
-Hayden Automotive Fan Controller
-R.S. Enthalpy Tuned Ecu (T25, N60, 370cc)
-Walbro 255lph Fuel Pump
-Blitz DD Blow Off Valve Recirculated (painted black)
-S13 SR20DET OEM Intake Box
-JGS Motor Mounts (rubber)
-Nismo Type B FPR
-Z32 Fuel Filter
-NGK BKR7E Spark Plugs
-Isis FPR Adapter
-Greddy 36mm Radiator Temp Switch Adapter
-Bosch Spark Plug Wire Set
-N60 MAF
-Circuit Sports Thermal Plenum Intake Gasket
-Circuit Sports Magnetic Oil Drain Plug
-Innovate 3833 Turbo Timer w/ Wideband
-XTD Stage 3 Clutch

Extras Installed
-DIF Solid Aluminum Steering Bushing
-Energy Suspension Polyurethane Steering

☆ ------------------ ☆ ------------------ ☆


2009: 17x8 / 17x9 Volk/Manarays, Cusco Comp-S Coilovers


2010: 18x10 XXR 521’s, PBM Pro Coilovers, Sleeper KA-T (210 WHP)


2011: 18x10 AME TM02 Tracers, Fully Built KA-T (350 WHP)


2012: 18x10 Work Bersaglio, Fully Built KA-T (350 WHP)