IL TW/ Pool ball shift knobs - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Typecast · 09-05-2012, 01:01 PM

Ok they are finally done and I have test fit them. I will send everyone a PM to get there address and such.

!!!Disclaimer!!!! If you wrench the shit of them and strip them its on you, you have been warned.

With that said I have cranked on them pretty good and nothing has happened yet. You may have to fiddle with where you start the threads so the number lines up right, it took me about 3 tries to figure it out.
Also they are bigger toward the base so they should slip over the threads about a half inch before you start to screw.

These are the darker marron-ish red the 7 is in the light the 15 I covered so you can see a little better

09-05-2012, 01:01 PM	#31
Typecast Zilvia Member Join Date: Apr 2012 Location: Champaign, Il Age: 41 Posts: 155 Trader Rating: (16) Feedback Score: 16 reviews	Ok they are finally done and I have test fit them. I will send everyone a PM to get there address and such. !!!Disclaimer!!!! If you wrench the shit of them and strip them its on you, you have been warned. With that said I have cranked on them pretty good and nothing has happened yet. You may have to fiddle with where you start the threads so the number lines up right, it took me about 3 tries to figure it out. Also they are bigger toward the base so they should slip over the threads about a half inch before you start to screw. These are the darker marron-ish red the 7 is in the light the 15 I covered so you can see a little better