BiG MiKE's Little Build! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

BiG MiKE86 · 11-14-2012, 07:39 PM

So as some of you know I recently parted out my SR in hopes of going with something more reliable and with much more power potential. So it was time to get rid of this paperweight and make space for something in an inline 6

Then I sold my beloved BBS's

And this is how she sat for a bit

Til I got these 17x9.5+15 / 18x9.5+15 MB Battles to roll on (not the greatest but they wuz cheap)

Stetched some rubber on em...

Then it was time to empty the bay and rip the front end off - here is where we stand now

\

Pulling as much as I can so we can get a nice coat of paint in the bay. Ill be picking up my 2j/R-154 this weekend and hopefully dropping her in to check fitment and decide if I am going to trim the radiator support for a bit more clearance. This isnt much of a build just yet (more of a demolition) so ill just throw in a few pics of the goodies that started rolling in this week.

Treadstone Cast Manifold

Precision 6266 .68a/r with 3-5/8" V-Band discharge

Xcessive engine & Trans Mounts

Tial MV-S, TRD Thermostat, and TRD Oil Filter

Complete 2JZGTE gasket set including water pump, idler pulley, tensioner, etc,!

So thats pretty much it for now. Ill be taking more pics as things come together... Until the next update

11-14-2012, 07:39 PM	#1
BiG MiKE86 Nissanaholic! Join Date: Mar 2007 Location: Ft. Lauderdale Age: 37 Posts: 1,776 Trader Rating: (12) Feedback Score: 12 reviews	BiG MiKE's Little Build! (2JZ-GTE Powered) So as some of you know I recently parted out my SR in hopes of going with something more reliable and with much more power potential. So it was time to get rid of this paperweight and make space for something in an inline 6 Then I sold my beloved BBS's And this is how she sat for a bit Til I got these 17x9.5+15 / 18x9.5+15 MB Battles to roll on (not the greatest but they wuz cheap) Stetched some rubber on em... Then it was time to empty the bay and rip the front end off - here is where we stand now \ Pulling as much as I can so we can get a nice coat of paint in the bay. Ill be picking up my 2j/R-154 this weekend and hopefully dropping her in to check fitment and decide if I am going to trim the radiator support for a bit more clearance. This isnt much of a build just yet (more of a demolition) so ill just throw in a few pics of the goodies that started rolling in this week. Treadstone Cast Manifold Precision 6266 .68a/r with 3-5/8" V-Band discharge Xcessive engine & Trans Mounts Tial MV-S, TRD Thermostat, and TRD Oil Filter Complete 2JZGTE gasket set including water pump, idler pulley, tensioner, etc,! So thats pretty much it for now. Ill be taking more pics as things come together... Until the next update __________________ Last edited by BiG MiKE86; 12-12-2012 at 09:07 AM..