Wont go into gear with clutch engaged

[208s14.5]

I just recently installed a new clutch into my car along with a new release bearing and pilot bearing. Had the car still on the lift started it and put it into gear and let it out and the tires starting spinning no problem, no issues with putting it in to gear no whining when the clutch is disengaged or engaged. After putting it back on the ground and going to back it out the car wont go into gear easily, you have to force it to go in and reverse just grinds. Slave cylinder extends just fine and the pedal feel is a tad bit stiffer then the previous (same type of clutch). The only issue i had while installing the clutch was that the pilot bearing no longer spins freely within the crank, pilot bearing is flush as the FSM required. I'm at a loss as to what this could be since it went into gear and drove just fine at first. Any ideas?

Motor is an s14 SR as well.