FL Built Sr20det Partout Aem standalone Twin Disk etc - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

tayloray · 11-15-2013, 01:43 PM

Alright so parting out this sr so i can move on to a 2jz setup.

Aem Series 2 standalone 3 bar map AIT setup-$900
Wiring specialties harness- $200
Innovate lc-1- $150
ID 1000's injectors with obx rail and regulator $350
Package deal since it's all wired together, $1400

Carbonetics Twin Disk, light use $600

S15 t28, with megan manifold and steel braided coolant/oil lines $650

Hks 272 Cams ti- springs/retainers $350

Toda cam Gears, small mark on the key way

good block recently machined with paper work, comes with arp hardware scat rods and weisco pistons all acl bearings. $800 including oil pans great way to put a built bottom end in your sr without the down time

stock head $100

s14 sr trans with isis shifter $200

s13 sr trans $150 no shifter

apexi n1 catback $150

Will post pictures tomorrow.

call/text 407-433-3188

11-15-2013, 01:43 PM	#1
tayloray Zilvia Addict Join Date: Jan 2011 Location: Orlando, Florida Posts: 661 Trader Rating: (3) Feedback Score: 3 reviews	Built Sr20det Partout Aem standalone Twin Disk etc Alright so parting out this sr so i can move on to a 2jz setup. Aem Series 2 standalone 3 bar map AIT setup-$900 Wiring specialties harness- $200 Innovate lc-1- $150 ID 1000's injectors with obx rail and regulator $350 Package deal since it's all wired together, $1400 Carbonetics Twin Disk, light use $600 S15 t28, with megan manifold and steel braided coolant/oil lines $650 Hks 272 Cams ti- springs/retainers $350 Toda cam Gears, small mark on the key way good block recently machined with paper work, comes with arp hardware scat rods and weisco pistons all acl bearings. $800 including oil pans great way to put a built bottom end in your sr without the down time stock head $100 s14 sr trans with isis shifter $200 s13 sr trans $150 no shifter apexi n1 catback $150 Will post pictures tomorrow. call/text 407-433-3188 __________________ Last edited by tayloray; 12-13-2013 at 10:32 AM..