tranny ?... a tiny bit more tech...

[s13silady]

ok a friend of mine recently just got his car back after a sohc to sohc swap(90)...he told me his clutch feels wierd.. so i drove it... once it grabs, it grabs fine except for the heavy shaking. we firgured this out to be the driveshaft is misaligned slightly and is causing some vibration... no biggy. the problem is the clutch pedal has super play in it and it sometimes hard to get in gear... i figured his sycros were going bad or might just need a new TOB...
we were on the freeway today and anytime we go above 4k his car loses power and shuts off... i figured this to be his speed sensor isnt hooked up and the speed cut-off is on the 4th and 5th gears (because the wires are cut and he has no speedo)...theres 2 sensors that arent hooked up, on is a sensor that plugs in directly into the tranny... then theres a sensor that has wires, then it goes into a clip sensor (male to female) that the wires were cut too... one of my questions is does anyone know what these sensors are and what colors the wires are, and which colored wire goes to which plugs? the reason i ask is because its not that the wires were cut, but actually pulled out of the clips...

and if anyone has any insight to what the other problems could be it would be of much help... we are also going to try to rebleed his clutch tomorrow, and i know that the clutch pedal has an adjustment bolt on it so im going to do that for hime tomorrow also...

any help is appreciated.. just wanted to know before we throw his car up on the lift tomorrow...