anyone with HKS type S fmic on their S14? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

ae86driftn · 05-12-2006, 10:22 PM

isn't there intructions of where to drill from?

There should be three small holes that are all ready there. line up the holesaw so that it roughly cuts through the middle of each small hole.
use a 3 1/2 inch hole saw, then use some vacuum lines to wrap around the hole for a clean install.

here I did this real quick....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-12-2006, 10:22 PM	#2
ae86driftn Leaky Injector Join Date: Apr 2003 Location: va Posts: 118 Trader Rating: (0) Feedback Score: 0 reviews	isn't there intructions of where to drill from? There should be three small holes that are all ready there. line up the holesaw so that it roughly cuts through the middle of each small hole. use a 3 1/2 inch hole saw, then use some vacuum lines to wrap around the hole for a clean install. here I did this real quick....