Emance Rom Tune Answers

[timtiminy]

Nosajton:
1)I am within driving distance of san diego. Could i possibly get a base tune for my setup from you then drive down there and have you fine tune my 240 on a dyno?
2)how much would you charge for something like this?
3)would you be able to fine tune, if I send you a dyno plot with air/fuel at a few different boost settings? I know this is something enthalpy offers.
4)I have heard that there is a possibiliy that your daughterboard quality is inferior to many other daughterboards. That it doesn't even have moisture protective coat and the circuit board is of cheap materials. This results in the cheap prices. Being able to do this for much cheaper because of the lack of quality in electronic components such as capacitors, resistors, and/or eeprom/flash chips. Is this just someones speculation or is there truth/partial truth in this statement? Tell us about the quality of the hardware of your system.

Thank you!

[nosajton]

1) 2) I pm'd you about getting your car tuned by us.
3) yes, if you have a dyno plot/sheet it will greatly help us.
4) our daughterboards have a life expectancy of 10 years, per manufacture.

anyhow, i warranty your tune for the life of it. if anything happends, i will fix it for free. there are no resistors on our daughterboards. the capacitors we use are Kemet and are known for their superior components. our chips are texas instruments the best out there. the flash chips are amtel or sst just to clear up the 'speculation' this statement is nonsense, whoever is telling you our quality is poor really does not know much about electronics.

Originally Posted by timtiminy

Nosajton:
1)I am within driving distance of san diego. Could i possibly get a base tune for my setup from you then drive down there and have you fine tune my 240 on a dyno?
2)how much would you charge for something like this?
3)would you be able to fine tune, if I send you a dyno plot with air/fuel at a few different boost settings? I know this is something enthalpy offers.
4)I have heard that there is a possibiliy that your daughterboard quality is inferior to many other daughterboards. That it doesn't even have moisture protective coat and the circuit board is of cheap materials. This results in the cheap prices. Being able to do this for much cheaper because of the lack of quality in electronic components such as capacitors, resistors, and/or eeprom/flash chips. Is this just someones speculation or is there truth/partial truth in this statement? Tell us about the quality of the hardware of your system.

Thank you!