rear strut question - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

nep · 09-21-2007, 07:47 PM

im installing my rear struts (kyb agx w/sportlines) and having a hell of a time tightening down the center lock nut. when i apply any torque to the nut, the strut rod rotates. i purchased a strap wrench to hold the strut rod, and that seems to have helped, however i am not able to secure the nut down as far as it was when stock.

that is as far as im able to tighten. when i pulled it off there was more like an inch of bolt protruding. the fsm says 13-17 ft lbs, but i put more torque than that to get it that far.

SiI40sx · 09-21-2007, 07:59 PM

Did u tighten it by hand?? try using power tool / impact gun.

kandyflip445 · 09-21-2007, 08:04 PM

IIRC, I used some vice grips to hold the top part sticking out, cause it had flat spots that worked perfect, and the used an open end wrench to turn it. Or if you have a ratcheting wrench you could put that on there and then put the vice grips on.

nep · 09-21-2007, 08:18 PM

Quote:

Originally Posted by kandyflip445

IIRC, I used some vice grips to hold the top part sticking out, cause it had flat spots that worked perfect, and the used an open end wrench to turn it. Or if you have a ratcheting wrench you could put that on there and then put the vice grips on.

ah, makes perfect sense. thanks

09-21-2007, 07:47 PM	#1
nep Zilvia Junkie Join Date: Jun 2007 Location: Oceanside, CA Posts: 370 Trader Rating: (8) Feedback Score: 8 reviews	rear strut question im installing my rear struts (kyb agx w/sportlines) and having a hell of a time tightening down the center lock nut. when i apply any torque to the nut, the strut rod rotates. i purchased a strap wrench to hold the strut rod, and that seems to have helped, however i am not able to secure the nut down as far as it was when stock. that is as far as im able to tighten. when i pulled it off there was more like an inch of bolt protruding. the fsm says 13-17 ft lbs, but i put more torque than that to get it that far.

09-21-2007, 08:04 PM	#3
kandyflip445 Post Whore! Join Date: Sep 2002 Location: Arden, NC Age: 40 Posts: 4,460 Trader Rating: (1) Rides Gallery: kandyflip445 Feedback Score: 1 reviews	IIRC, I used some vice grips to hold the top part sticking out, cause it had flat spots that worked perfect, and the used an open end wrench to turn it. Or if you have a ratcheting wrench you could put that on there and then put the vice grips on. __________________ My 240 vBgarage

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-21-2007, 07:59 PM	#2
SiI40sx BANNED Join Date: Mar 2006 Location: Bass bumpin, mind trippin Age: 38 Posts: 3,394 Trader Rating: (0) Rides Gallery: SiI40sx Feedback Score: 0 reviews	Did u tighten it by hand?? try using power tool / impact gun.