head bolt torque specs, for both KA and SR?

[statik]

Originally Posted by projectRDM

NO! unless you want a blown head gasket.

29ft-lbs
59ft-lbs
loosen
29ft-lbs
59ft-lbs

The first two steps stretch the bolt to spec.

My bad, on the next page in the sr fsm after tightening to 30 it calls for turning all the bolts 90* with an angle wrench and then turning them all again another 90*, and looking at the "elastic" image next to the studs it looks like its supposed to be just slightly more than 60 in the end. With new studs you might want to do the last part in 2 steps as the fsm calls for.