Nardi horn, always on?

[khilgers]

it's a 330mm deep corn so I removed the trim ring. I looked everything over and the only thing I could find out of the ordinary was this:



the red positive seems to have some bare wire showing, but not much. Thoughts?

[A Spec Products]

Originally Posted by khilgers

it's a 330mm deep corn so I removed the trim ring. I looked everything over and the only thing I could find out of the ordinary was this:

the red positive seems to have some bare wire showing, but not much. Thoughts?

Cut a square of elec tape

Put over that spot

Then try push in horn again

See if still goes off

Can't hurt

Oh, actually, also take note of the grounding ring that is in between the wheel + quick release

Sometimes depending on where you position the ring, the metal tab that bends down also can cause it to constantly be on

Essentially just take notice where those wires are exposed, especially with the metal contact rubber covers, sometimes they move off the plug, and it touches the plug to the quick release wall