Help Ka-t Gods. Stalling Problem! Blow Through Did Not Help. Sorta. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

beatd · 07-11-2008, 11:00 AM

the bov is tighten down. but how do i adjust it so it would operate right? should it be on the border of being loose/tight?

hunter8411 · 07-11-2008, 11:07 AM

With the greddy type, there is a a nut and rod on the top that takes a alan wrench to tighten/loosen. So you loosen the nut at the top, then loosen up the rod.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-11-2008, 11:00 AM	#1
beatd Leaky Injector Join Date: Jun 2007 Location: NJ Age: 39 Posts: 87 Trader Rating: (1) Feedback Score: 1 reviews	the bov is tighten down. but how do i adjust it so it would operate right? should it be on the border of being loose/tight?

07-11-2008, 11:07 AM	#2
hunter8411 Zilvia Addict Join Date: Sep 2005 Location: SoCal Age: 40 Posts: 664 Trader Rating: (20) Feedback Score: 20 reviews	With the greddy type, there is a a nut and rod on the top that takes a alan wrench to tighten/loosen. So you loosen the nut at the top, then loosen up the rod.