installing stainless steel turbo lines. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

whereda40at · 09-08-2008, 12:04 AM

the way i did it is.
1. take off the hard line
2. cut about 2" of the straight part of the hard line with copper pipe cutters
3. put 1" of the hard line in the stainless steel line and tighten.
4. test the line to see if it leaks. run water threw it and plug the end of the hard line and make sure it doesnt leak.
5. push the hard line into the hose that the hard line was in.
6. clamp down and go.

09-08-2008, 12:04 AM	#2
whereda40at Zilvia FREAK! Join Date: Mar 2007 Location: where 240's are few and far between Age: 37 Posts: 1,039 Trader Rating: (3) Feedback Score: 3 reviews	the way i did it is. 1. take off the hard line 2. cut about 2" of the straight part of the hard line with copper pipe cutters 3. put 1" of the hard line in the stainless steel line and tighten. 4. test the line to see if it leaks. run water threw it and plug the end of the hard line and make sure it doesnt leak. 5. push the hard line into the hose that the hard line was in. 6. clamp down and go. __________________ WORLDS FASTEST T-2 TURBO 240 ON 93 OCTANE! 10.79 @ 124 MPH WITH A 1.48 60'

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode