not going in gear - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

ocska04 · 04-16-2009, 07:32 PM

yes i replaced the clutch and throwout bearing and i also have a new nismo slave cylinder. When i try to bleed the clutch it only builds pressure about a 1/4 off the clutch pedal from bottom to top but when i open the bleeder the fluid comes out with pressure and no air in the system. I tried adjusting the rod for the pedal so many times and no solution

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-16-2009, 07:32 PM	#7
ocska04 Zilvia Member Join Date: Mar 2005 Location: L.A Posts: 151 Trader Rating: (0) Feedback Score: 0 reviews	yes i replaced the clutch and throwout bearing and i also have a new nismo slave cylinder. When i try to bleed the clutch it only builds pressure about a 1/4 off the clutch pedal from bottom to top but when i open the bleeder the fluid comes out with pressure and no air in the system. I tried adjusting the rod for the pedal so many times and no solution