I set my SR on its oil pan - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Bill Roberts · 08-25-2003, 10:25 PM

Did you have to? Was their not another way?

I would not trust it without making sure it did not deform. It is very tight in there. Could spell trouble. Not a move I would want to perform.

For petes sake, pull the pan and take a look and measure.

Next thing..Yes gasket seal is fine for putting the pan back on.

Nice pitcure of the cars and clip. You got a hoist and engine stand right?

08-25-2003, 10:25 PM	#1
Bill Roberts Zilvia FREAK! Join Date: May 2003 Location: S FL. Posts: 1,538 Trader Rating: (0) Feedback Score: 0 reviews	Did you have to? Was their not another way? I would not trust it without making sure it did not deform. It is very tight in there. Could spell trouble. Not a move I would want to perform. For petes sake, pull the pan and take a look and measure. Next thing..Yes gasket seal is fine for putting the pan back on. Nice pitcure of the cars and clip. You got a hoist and engine stand right? Last edited by Bill Roberts; 08-25-2003 at 10:29 PM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode