VERY LONG Rebuild Parts List. Please tell me what I can add/take off it. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

deviousKA · 11-03-2003, 12:27 AM

Forged pistons/rods are always going to cost a grip. dont expect to pay less than 100 per piston and 150-200 per rod, and then rings. Do you want to lower your compression? or want oem spec pistons? You can get "premium" pistons that cost more the regular cast and not as much as forged. Machinist will tell you what you need as far as main and rod bearings, they shouldnt have to go 20 under unless there is damage or it is very worn (you dont want to have to grind the crank to much unless necessary). If those toga bearings cost much more than aftermarket oem equivalent, i wouldnt buy them and save the money. OEM type bearings (many aftermarket manuf.) properly installed with mic'd/ground crankshaft with proper size can withstand plenty of horsepower and longevity.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-03-2003, 12:27 AM	#5
deviousKA Zilvia Junkie Join Date: Jan 2003 Location: Idaho Posts: 437 Trader Rating: (0) Feedback Score: 0 reviews	Forged pistons/rods are always going to cost a grip. dont expect to pay less than 100 per piston and 150-200 per rod, and then rings. Do you want to lower your compression? or want oem spec pistons? You can get "premium" pistons that cost more the regular cast and not as much as forged. Machinist will tell you what you need as far as main and rod bearings, they shouldnt have to go 20 under unless there is damage or it is very worn (you dont want to have to grind the crank to much unless necessary). If those toga bearings cost much more than aftermarket oem equivalent, i wouldnt buy them and save the money. OEM type bearings (many aftermarket manuf.) properly installed with mic'd/ground crankshaft with proper size can withstand plenty of horsepower and longevity.