No start, and lost at this point... - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

fueled by hate · 12-21-2010, 10:24 PM

grab a meter and check to see if you get full 12v at the ignition switch when you turn the key to on. Check the constant 12v power and check to see if the starter signal wire gets 12v when turning to the key to the cranking position. Then test the signal wire on the other end at the starter. My friend had a short in his starter signal wire and I had to run a new one for him.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-21-2010, 10:24 PM	#6
fueled by hate Zilvia Member Join Date: Sep 2007 Location: norcal Posts: 290 Trader Rating: (12) Feedback Score: 12 reviews	grab a meter and check to see if you get full 12v at the ignition switch when you turn the key to on. Check the constant 12v power and check to see if the starter signal wire gets 12v when turning to the key to the cranking position. Then test the signal wire on the other end at the starter. My friend had a short in his starter signal wire and I had to run a new one for him.