My first DOHC SR20DET Cylinder Head Build (Shimming Issue) - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

green_pea · 05-02-2012, 05:22 PM

ok so if you are using HLA, you shouldnt have to use feeler gauges as the miniscule amount of high gained up top after the lapping was done will not matter because the HLA will take up the slack. If you can get your hands on an old HLA and disassemble it, you can make a tool to measure the shim height like the FSM states. hope this helps you

heres one i made earlier

05-02-2012, 05:22 PM	#6
green_pea Join Date: May 2012 Location: Sydney, Australia Posts: 20 Trader Rating: (0) Feedback Score: 0 reviews	ok so if you are using HLA, you shouldnt have to use feeler gauges as the miniscule amount of high gained up top after the lapping was done will not matter because the HLA will take up the slack. If you can get your hands on an old HLA and disassemble it, you can make a tool to measure the shim height like the FSM states. hope this helps you heres one i made earlier __________________ nationaldriftographic.blogspot.com/

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode