car won't start after swap

[XXX4life]

The car is 90 240 that had asingle cam. Swappped in a dual cam following the article in the tech section. Fuel and spark is good. Timing is fine. Compression is fine. The engine will give me a little sputter than nothing. Just cranks. Swapped out for some non fuel fouled plugs and the still the same issue. I tried searching to see if there is a common sensor that goes bad hat won't allow it to start. I don't yet have the consult plug to wire in. All grounds are attatched and secure. I have one plug over buy the coil that is not being used. Its a 2 pin with a brown and a black wire. Any thing I'm missing? Thanks

[andrave]

I dunno mine sounds pretty much the same as yours. how is your timing? maybe the dist. is off a tooth? thats pretty common...

[XXX4life]

the timing seems to be fine and even if it's off it shouldn't bee of enough for it not to run, right now i don't know what to do, i'm beyond mad

[andrave]

yeah thats the same shit mine was doing too... timing should have been close enough to turn over... *shrugs*
if you figure it out tell me, cause I need to get mine running as well.

[XXX4life]

i'm gonna set the motor to TDC and check the Distributor, i think it might be off that's the only thing i can think of

[phrozen]

:hammer: :hammer: :hammer: