S14 RHD conversion question (gauge cluster)

[EnemyS15]

using the dash harness you will have to cut and lengthen many parts to it.

I just sourced a jdm dash harness and chassis harness, everything is plug and play. The only thing you would have to repin is the rear harness into the SMJ, to match the dash harness. If you go that route, I have an entire diagram madeout for s14 zenki usdm to jdm rear.

[magermeister]

Originally Posted by EnemyS15

using the dash harness you will have to cut and lengthen many parts to it.

I just sourced a jdm dash harness and chassis harness, everything is plug and play. The only thing you would have to repin is the rear harness into the SMJ, to match the dash harness. If you go that route, I have an entire diagram madeout for s14 zenki usdm to jdm rear.

That would be sweet if you could send that my way man. I actually found your build months ago and it re-inspired me to for see my dream. I read and gained a good deal of knowledge from your write up. I was hoping to see the rest of the photos during your build but most of them are not loading and haven't loaded o the page for months. Any knowledge you car to share man will GREATLY appreciated as this has been a dream of mine for 11 years now and will be my daily so I want it reliable of course. I seen so many people cutting firewalls and I just knew there had to be a better way.