HELP: RB clutch on KA24DE not disengaging - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

2.5T_/<ouki · 05-08-2016, 12:50 PM

Any help?
Basically, not sure if it matters, but i noticed that getting the PP onto the flywheel WITH the clutch disk installed is VERRRRRY difficult, took 2 of us. ALmost as if the clutch disk is too thick or somethings not right? With the clutch disk installed and trying to put the PP on, it BARELY catches on the edge of the dowel pins.

is this normal? I cannot move the clutch fork by hand either. Not even the slightest. Never had a this problem nor any problem with clutch installs.

Without the clutch disc installed, the PP plate sits on it fine.

WITHOUT clutch disk

WITH clutch disk installed

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-08-2016, 12:50 PM	#1
2.5T_/<ouki Zilvia FREAK! Join Date: Oct 2011 Location: SoCal Posts: 1,150 Trader Rating: (13) Feedback Score: 13 reviews	Any help? Basically, not sure if it matters, but i noticed that getting the PP onto the flywheel WITH the clutch disk installed is VERRRRRY difficult, took 2 of us. ALmost as if the clutch disk is too thick or somethings not right? With the clutch disk installed and trying to put the PP on, it BARELY catches on the edge of the dowel pins. is this normal? I cannot move the clutch fork by hand either. Not even the slightest. Never had a this problem nor any problem with clutch installs. Without the clutch disc installed, the PP plate sits on it fine. WITHOUT clutch disk WITH clutch disk installed