Cel Code 35: California: Exhaust Gas Temp Sensor: Ka24e ? - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

spray2020 · 02-15-2017, 10:23 PM

Looking for any others who have gone through this with this code before.

My 240 is a 89' ka24e, originally auto, so the sensor is in the auto location up top on the intake manifold.

Car has been swapped to manual, and still has original auto ecu.

I have cel 35 and 45 (injector leak) - Just trying to figure out what I should do with this sensor?

Clean it? Put it in the manual location (in the back by the egr stuff)? Or just buy a new one and put it in the original location?

Any suggestions would be appreciated, need to get smog done very soon!

haamess · 03-17-2017, 01:07 AM

I just replaced the auto ecu with a non california 5 speed ecu. That fixed the issue.

soryu · 03-17-2017, 01:22 AM

I think u might be able to put a resistor in there(harness connector) to get the the code off.
You can get the fsm to get more info on testing the sensor and the wiring.

02-15-2017, 10:23 PM	#1
spray2020 Zilvia Member Join Date: Oct 2011 Location: So Cal Age: 38 Posts: 268 Trader Rating: (1) Feedback Score: 1 reviews	Cel Code 35: California: Exhaust Gas Temp Sensor: Ka24e ? Looking for any others who have gone through this with this code before. My 240 is a 89' ka24e, originally auto, so the sensor is in the auto location up top on the intake manifold. Car has been swapped to manual, and still has original auto ecu. I have cel 35 and 45 (injector leak) - Just trying to figure out what I should do with this sensor? Clean it? Put it in the manual location (in the back by the egr stuff)? Or just buy a new one and put it in the original location? Any suggestions would be appreciated, need to get smog done very soon! __________________ S13 Silvia Lip's f/s :www.codycasale.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-17-2017, 01:07 AM	#2
haamess Join Date: Mar 2017 Location: California Age: 28 Posts: 1 Trader Rating: (0) Feedback Score: 0 reviews	I just replaced the auto ecu with a non california 5 speed ecu. That fixed the issue.

03-17-2017, 01:22 AM	#3
soryu Zilvia FREAK! Join Date: Jul 2011 Location: Socal, I.E. Posts: 1,199 Trader Rating: (17) Feedback Score: 17 reviews	I think u might be able to put a resistor in there(harness connector) to get the the code off. You can get the fsm to get more info on testing the sensor and the wiring.