Replacing lost FLCA rod ends - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

derass · 04-05-2017, 10:03 PM

That thread could be anything really, but 3/4" looks about right. You could probably check with a bolt or tap too. But that's a big size and might be hard to find easy and cheap. Maybe a machinist could help you.

Also those spacers might not match the width of the slot in the subframe. You could try to force everything together with either a hammer or pry-bar, possibly have those turned down on a lathe, or have new ones machined up.

Don't know anything about that AFCO brand, but QA1 and Aurora are the big names I know for rod-ends.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-05-2017, 10:03 PM	#2
derass Zilvia FREAK! Join Date: Jun 2010 Location: Toronto, ON Age: 37 Posts: 1,182 Trader Rating: (0) Feedback Score: 0 reviews	That thread could be anything really, but 3/4" looks about right. You could probably check with a bolt or tap too. But that's a big size and might be hard to find easy and cheap. Maybe a machinist could help you. Also those spacers might not match the width of the slot in the subframe. You could try to force everything together with either a hammer or pry-bar, possibly have those turned down on a lathe, or have new ones machined up. Don't know anything about that AFCO brand, but QA1 and Aurora are the big names I know for rod-ends.