Tips for drilling s13 dash for gauges. - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

andisan · 03-07-2019, 08:49 PM

I remember doing it on my brothers civic

I cut the top layer off and exposed the bare plastic of the dash and then just used the right size hole saw on the plastic of the the bare dash, so you won’t rip material off
Also I left the hole a little smaller then the gauge so it’s a snug fit

I would do an angle adaptor to it so you can have a good view of them from the driver side

Sent from my iPhone using Tapatalk

03-07-2019, 08:49 PM	#15
andisan Nissanaholic! Join Date: Oct 2007 Location: Lompoc CA 805!!!! Age: 41 Posts: 2,063 Trader Rating: (12) Feedback Score: 12 reviews	I remember doing it on my brothers civic I cut the top layer off and exposed the bare plastic of the dash and then just used the right size hole saw on the plastic of the the bare dash, so you won’t rip material off Also I left the hole a little smaller then the gauge so it’s a snug fit I would do an angle adaptor to it so you can have a good view of them from the driver side Sent from my iPhone using Tapatalk __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode