Got a few questions about doing a swap

[SiI40sx]

This swap is going to be on a 1991 240sx Hatch (Auto) Engine is coming from a front clip Redtop (5spd)
I pretty much have everything down, my 2 questions are:

1. Can I use the Clutch Bracket and Pedal from the Front Clip onto my USDM 240?

2. Im using heavythrottle for reference for the harness. What I understand is that I ONLY need to extend the P/S & MAFS wires and re-wire the end of the SR harness (the 3 plugs) to match the end of the KA harness (2 plugs) as for everything else, its plug n play.


Everything else for the swap should go smoothly. Im going to prep everything and double check everything before I drop in the engine. This is my second time swaping a 240 but my first time doing a harness and auto to 5spd. Any advice that would make the harness and 5spd easier will be very helpful, thanks for reading all that crap.