How to pull codes off an E5 ECU - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

gotboost2jz · 09-06-2009, 05:07 PM

I have an E5 ecu on my SR swapped S14 and when I go to check codes, the dash/check engine light does not flash to give me the code. I was told that there is a way to wire an LED light to the ecu so that I can get codes. Anyone know how or have the link that shows you?

p.s. I found one but it was in technobabble lingo above my simpleton wiring mind.
How to pull codes from an E5 blacktop ecu...anyone know?: SR20DET Forum (rear-drive): Nissan Forums / Infiniti Forums - NICOclub

If you can translate into english, I'd be very appreciative. Thanks

Also, can I do a straight swap from my E5 ecu to a red top ecu that does have an LED light? Or would it just be easier in the long run to wire one in?

09-06-2009, 05:07 PM	#1
gotboost2jz Leaky Injector Join Date: Jun 2008 Location: Ohio Age: 37 Posts: 145 Trader Rating: (5) Feedback Score: 5 reviews	How to pull codes off an E5 ECU I have an E5 ecu on my SR swapped S14 and when I go to check codes, the dash/check engine light does not flash to give me the code. I was told that there is a way to wire an LED light to the ecu so that I can get codes. Anyone know how or have the link that shows you? p.s. I found one but it was in technobabble lingo above my simpleton wiring mind. How to pull codes from an E5 blacktop ecu...anyone know?: SR20DET Forum (rear-drive): Nissan Forums / Infiniti Forums - NICOclub If you can translate into english, I'd be very appreciative. Thanks Also, can I do a straight swap from my E5 ecu to a red top ecu that does have an LED light? Or would it just be easier in the long run to wire one in? __________________ 1995 240sx SE - 1JZ

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode