Clutch hydraulic problems?! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Toahk · 08-26-2003, 09:44 PM

Cluch has a Lot of freeplay since today, I was shifting and the pedal hit the floor and didnt come back up. I pulled it up with my hand and it worked ok untill I got home. I drove it some more and the pedal stays on the floor every 10 times depressing it while shifting. I checked for spots to see if there was a leak and didnt see any, and the fluid is where its always been when I look in the Clutch master cylinder. Could this be air in the system? A bad master/slave cylinder? If it is a bad MC/SC do they sell rebuilt kits for them? thanks in advance. Also could it be the clutch spring?

Bill Roberts · 08-26-2003, 09:50 PM

Slave giving out, time to replace it and have a tight clutch.

Leak in the system.

Dont futz with it, replace the slave and bleed. Master is a parallel line. Look for leaks, replace CMC and SC and you are in biz.

08-26-2003, 09:44 PM	#1
Toahk Zilvia Junkie Join Date: Jun 2003 Location: N. Cali Age: 39 Posts: 434 Trader Rating: (0) Feedback Score: 0 reviews	Clutch hydraulic problems?! Cluch has a Lot of freeplay since today, I was shifting and the pedal hit the floor and didnt come back up. I pulled it up with my hand and it worked ok untill I got home. I drove it some more and the pedal stays on the floor every 10 times depressing it while shifting. I checked for spots to see if there was a leak and didnt see any, and the fluid is where its always been when I look in the Clutch master cylinder. Could this be air in the system? A bad master/slave cylinder? If it is a bad MC/SC do they sell rebuilt kits for them? thanks in advance. Also could it be the clutch spring?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

08-26-2003, 09:50 PM	#2
Bill Roberts Zilvia FREAK! Join Date: May 2003 Location: S FL. Posts: 1,538 Trader Rating: (0) Feedback Score: 0 reviews	Slave giving out, time to replace it and have a tight clutch. Leak in the system. Dont futz with it, replace the slave and bleed. Master is a parallel line. Look for leaks, replace CMC and SC and you are in biz.