sr20det bleeder valve thread pitch - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Jersthecool · 06-11-2013, 05:55 PM

I've had an autometer water temp gauge in my car that never had the sensor installed and I've found the replacement one I need to buy and the thread pitch is 1/8" and I'd like to install it directly into the bleeder valve on the water inlet if possible as I don't want to go and buy an adapter and cut my rad hoses to install it. If the thread isn't the same anyone know if it's possible to re-thread the sensor to the thread of the bleeder valve?

This is what the sensor is btw
http://www.autometer.com/cat_accesso...il.aspx?vid=33

japslapsilvia · 06-12-2013, 07:59 AM

M6 1.0 is the size of the stock bleeder

06-11-2013, 05:55 PM	#1
Jersthecool Zilvia Junkie Join Date: Jul 2010 Location: Calgary, Canada Posts: 342 Trader Rating: (0) Feedback Score: 0 reviews	sr20det bleeder valve thread pitch I've had an autometer water temp gauge in my car that never had the sensor installed and I've found the replacement one I need to buy and the thread pitch is 1/8" and I'd like to install it directly into the bleeder valve on the water inlet if possible as I don't want to go and buy an adapter and cut my rad hoses to install it. If the thread isn't the same anyone know if it's possible to re-thread the sensor to the thread of the bleeder valve? This is what the sensor is btw http://www.autometer.com/cat_accesso...il.aspx?vid=33

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode