CA Annual Selling all things 240 Sale. Oem, aftermarket, SR, check it out

[Purestock240]

I have all of this sitting around and havent even driven my 240 yet this year...
Paypal or e-transfer
PM or text if interested 705 441 2693

I'm parting out pretty much complete car lots of OEM and aftermarket stuff. I'll update it as I go along but here's a start. All parts are for s13 SR unless otherwise stated

SR20 coil packs, $25 each,
SR20 throttle body (will need TPS replaced) $40
SR20 Waterneck $25
SR20 temp sensor $25
SR20 thermostat $25



SR20 Eagle Rods and CP Pistons,
Rods: http://www.frsport.com/Eagle-CRS5365...ds_p_1367.html
Pistons: http://www.frsport.com/CP-Pistons-SC...-1_p_8504.html
Ignore the fact that theyre dirty, pic was taken right when they where pulled.
New these are $1106.32 from FRsport without bearings, plus bearings, plus tax, plus shipping
I'll sell them for $800 with rod bearings.


SR20 Oil pan, scratches but no dents $50


SR timing chain guides. Like new very little wear $60


SR valve cover, with gasket. $70


SR valve shims, $60


SR20 red top head (with cam caps and rockers, not pictured), about 15,000 miles on rebuild. take all of it $300
lifters $80
rockers $80
springs $40
valves $60
bare head and caps $75 but not for sale unless a few other small things sell off it.


SR20 Oil block with sensor $50
SR20 Cam angle sensor sold
SR20 motor mount brackets sold
SR20 Alternator bracket $40
SR20 Dipstick $40
SR20 Coil pack sub harness, sold
SR20 Knock Sensor and harness sold
SR20 OEM Intake support $20
SR20 Coolant block with sensors and lines sold
SR20 Dust sheild tranny plate $50




SR20 Intake top Half $40
SR20 Intake Bottom Half $35
SR20 Fuel Rail $30, +$10 for caps and screws (not pictured)



HKS Cam Gears, asking for $250, these retail for $380


SR IACV sold


SR20 Rockers, $80
SR20 Crank Pulley $50
SR20 Head Bolts and Washers $50
SR20 OEM Water Pump with low miles $40



SR Timing Chain, low km $40


Isis style N62 Maf, Brand new $80


Subframe spacers, $75
Isis control arms, $60 a pair


Will Update with more later! Complete engine is being parted out. Forged bottom end, Head and block, Accessories, N62 maf and plug.

[Po_31]

Do you still have the is is arms

[Purestock240]

Originally Posted by Po_31

Do you still have the is is arms

yes i do 10chr