Another Wheel Fitment Thread

[Engmus]

Greetings Zilvia Crew,

First, I have read the above stickied suspension and Offset threads, and I did a fair bit of searching.

My vehicle is a 91 240sx, that has the following suspension modifications.

Front: KYB Shocks, RSR Race Springs, SPC Tension Rods, ISR Sway Bar, Moog End Links and Moog Ball Joints, New Wheel bearings, Prothane Bushing Kit, etc.

Rear: Prothane bushing kit, New Ball joints, KYB Shocks, RSR Down Springs, Etc

(You get the picture)

From my reading it seems a set of RUCA would be appreciated as the car is lowered, second my buddy is selling off his XXR 527's. The rears are 17x9.75 + 25, his fronts i'm unclear on but apparently wont fit stock suspension.

Two questions spur from this I haven't seen clear information on.

1. With a minimal drop of , Ride Height - F: -1.4, Ride Height - R: -1.2 should I invest in a set of RUCA's to maintain a good geometry suspension?

2. Considering the fact I dont have coils , and im not interested in buying a set if at all possible, what size wheel can I run safely up front? I'd like to avoid spacers and if possible i'd like to run a 17x something wheel.

I am prepared to roll my fenders.

Thanks for the help.