Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Go Back   Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum > General > Chat

Chat General Discussion About The Nissan 240SX and Nissan Z Cars


Reply
 
Thread Tools Display Modes
Old 12-03-2013, 07:44 PM   #1
93s13wa
 
Join Date: Aug 2013
Location: wa
Posts: 9
Trader Rating: (0)
93s13wa is an unknown quantity at this point
Feedback Score: 0 reviews
Unhappy help smoke under hood and no start???

93 s13 hatch ka24de



well long story short i broke a chain guide or should i say the P.O. was an idiot
and took the lower guide off and the chain was rubbing on the bolt...

so i pulled the engine and fix it sealed everything up.... i put the engine back in and had to screw with the distributer to time right ....finally got it to idle without missing

and that was fine... I'm running just the header... until i can go down the street and get a flange welded up...

im not sure if the timing was messed up or not because i don't have a light

anyways i drove down the street revs seemed good about 15 at idle but loud as shit because it was just the header also it wasn't warm so they explains the high idle

i literally drive down the street pull into the garage and shut it off ....then i try and start it and "smoke" under the right side of the hood as if your looking from the drivers seat...and i look an see flames roll out of the exhaust as i crank but no spark, nothing no slight running .... i quickly pop the hood and see nothing a little smoke maybe coming from near the intake????

and now no start??? could there be some predet stuff that could have affected the engine just going down the street? please help I'm at a loss i have no idea i thought i figured it out ,,, but i guess this s13 is going fight me to the bitter end.
93s13wa is offline   Reply With Quote
Sponsored Links
Old 12-03-2013, 07:48 PM   #2
silva.240
Zilvia Member
 
Join Date: Apr 2007
Location: so.cal
Age: 38
Posts: 229
Trader Rating: (5)
silva.240 is an unknown quantity at this point
Feedback Score: 5 reviews
i'm stumped too... its cranking, you have spark, it seems like you dont' have fuel pressure?
silva.240 is offline   Reply With Quote
Old 12-03-2013, 07:59 PM   #3
deolio
Post Whore!
 
deolio's Avatar
 
Join Date: Mar 2007
Location: Sacramento, CA
Age: 35
Posts: 4,694
Trader Rating: (13)
deolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfectiondeolio is close to perfection
Feedback Score: 13 reviews
Quote:
Originally Posted by 93s13wa View Post
ka24de
found your problem
__________________
deolio is offline   Reply With Quote
Old 12-03-2013, 08:08 PM   #4
93s13wa
 
Join Date: Aug 2013
Location: wa
Posts: 9
Trader Rating: (0)
93s13wa is an unknown quantity at this point
Feedback Score: 0 reviews
Quote:
Originally Posted by silva.240 View Post
i'm stumped too... its cranking, you have spark, it seems like you dont' have fuel pressure?
I just installed a walbro 155 like a month ago and it smelt like gas

I'm pretty sure my plugs are wet but it's late here I don't have time to check it ... I'm so stumped... Maybe my wiring got messed up? But why would it run then quit and smoke?
93s13wa is offline   Reply With Quote
Old 12-06-2013, 10:21 AM   #5
Fuego
Zilvia Addict
 
Join Date: Nov 2011
Location: Las Vegas
Age: 34
Posts: 629
Trader Rating: (0)
Fuego is an unknown quantity at this point
Feedback Score: 0 reviews
I'm a little confused because you said crank no spark with flames coming out of the exhaust. And are you now getting nothing at all? Does the motor still turn, just not over?
__________________
Fuego is offline   Reply With Quote
Old 12-06-2013, 10:58 AM   #6
93s13wa
 
Join Date: Aug 2013
Location: wa
Posts: 9
Trader Rating: (0)
93s13wa is an unknown quantity at this point
Feedback Score: 0 reviews
Quote:
Originally Posted by Fuego View Post
I'm a little confused because you said crank no spark with flames coming out of the exhaust. And are you now getting nothing at all? Does the motor still turn, just not over?
I stand corrected I am getting spark it just would not run or pop or partially start ....I ended up changing my ditributor position turning it almost all the way clockwise and it started I think driving it cold and with the timing not right it fouled my plugs some how ? Also an unrelated question can I sauder in a new temp sending plug on my upper harness??? http://m.youtube.com/watch?v=mBQldvP...e_gdata_player&fs=1" width="644" height="390">http://m.youtube.com/watch?v=mBQldvP...e_gdata_player&fs=1" />http://m.youtube.com/watch?v=mBQldvP...e_gdata_player">http://www.youtube.com/watch?v=http://m.youtube.com/watch?v=mBQldvP...e_gdata_player
93s13wa is offline   Reply With Quote
Old 12-09-2013, 06:58 PM   #7
Gordo714
Zilvia Junkie
 
Gordo714's Avatar
 
Join Date: Jun 2008
Location: 714
Posts: 510
Trader Rating: (10)
Gordo714 is an unknown quantity at this point
Feedback Score: 10 reviews
Engine needs air,fuel and ignition

Check fuses, check power at fuel pump and check for spark,
Process of elimination
__________________
Gordo714 is offline   Reply With Quote
Old 12-13-2013, 07:17 AM   #8
s14wannabe
Leaky Injector
 
Join Date: Feb 2012
Location: milwaukee, wi
Posts: 64
Trader Rating: (0)
s14wannabe is an unknown quantity at this point
Feedback Score: 0 reviews
Thats not good. Might be easier to take it in to a shop
s14wannabe is offline   Reply With Quote
Reply

Bookmarks

Tags
240sx, distributor, smoke



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 09:17 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
vB.Sponsors
Copyright ? 1998 - 2022, Zilvia.net