Arp

[jdmgtom]

Purchased ARP main head stud bolts and their ARP tread chaser and ARP tread sealer which both was recommended in the instructions for my S13 SR20det. I used the thread chaser in each hole, I cleaned each with compressed air, I made sure every bolt went in smoothly, HAND TIGHTEN ONLY. Went in the torque sequence pattern. 30ft. lb went good, then 60ft. lb.. then when i went to 90 like instructed.. bolt hole #7 to the front RT of the motor would not clcik at 90, so I skipped being scared to strip something. so 9/10 was at 90 ft. lb at this point. Went back to #7 bolt at 80 ft. lb, that clicked then to 85 ft lb...it compelely stripped.. had to removed the head that I just installed with the new Apexi HG to remove that head bolt, had the treading from the block on the bolt.... I pretty much need a new block due to ARP screwing me, don't know if this will be repairable. Being so close to completing my build to just be knocked back down...I regret purchasing ARP and honestly should have reused my OE bolts... that's how my experience using ARP went.