Window Regulator Pulley Fix

[slider2828]

Hey All,

So S13's window regulator pulleys are all nylon plastic, which kid of sux.
As you can see its broken in the upper left hand corner. Usually there is a pulley with a pin through it.





To Fix - Dremel through the back side of the rivet and pull out the entire pulley
Its roughly a 1/4" hole.


Get Part Number 9466T54 - Pulley for Wire Rope
Ball Bearing, 3/64" Rope Diameter, 35 lb., 1/4" Shaft Diameter, Nylon

1 - 1/4" round bolt with machined head because you need to be low profile
1 - 1/4" jam nut case you also need low profile
2 - 1/4" round lock washer.
(you don't need the washer in the picture....)


Bolt through the cable side of the pulley, then behind the pull and the regulator plate, put a lock washer to offset it, then on the other side put lock washer and jam nut with locktite

[brndck]

Plus rep for you sir!!!

[slider2828]

Originally Posted by brndck

Plus rep for you sir!!!

Thanks man.... the motor and track was good, so I thought it'd be a waste of money to through out something could cost me 15 bux to fix.....