cant gap plugs bigger then 0.23" but why?

[jedi03]

do you guys have a diagram to follow for anyone else to swap to the same?

[tunermt]

Originally Posted by jedi03

do you guys have a diagram to follow for anyone else to swap to the same?

sure super easy to swap over to the R35 coils.

- s13/14 you'll need to bypass the ignitor (s15 doesn't use the ignitor so nothing to do there)

- R35 coils are 3 wire just like the OEM sr20det coils (12v, cylinderhead/chassis ground, signal from ECU). **i'll grab the pin out/picture and tomorrow and update this post for you.

[inopsey]

Originally Posted by tunermt

sure super easy to swap over to the R35 coils.

- s13/14 you'll need to bypass the ignitor (s15 doesn't use the ignitor so nothing to do there)

- R35 coils are 3 wire just like the OEM sr20det coils (12v, cylinderhead/chassis ground, signal from ECU). **i'll grab the pin out/picture and tomorrow and update this post for you.

what about the connection between the sr coilpack harness and R35 coils? is it plug and play

[tunermt]

Originally Posted by inopsey

what about the connection between the sr coilpack harness and R35 coils? is it plug and play

No you need the R35 coil plugs and pins to make a new coil harness or mod you stock one. (i recommend making a new one) Alternatively you can just buy one if you don't want to make a harness, they are only 125-150 usd depending on the brand you get.

[jr_ss]

Originally Posted by inopsey

what about the connection between the sr coilpack harness and R35 coils? is it plug and play

The SR harness plugs directly into the VQ37 coils. I am not sure about the VR38 coils.

[tunermt]

Originally Posted by jr_ss

The SR harness plugs directly into the VQ37 coils. I am not sure about the VR38 coils.

vr38/r35 coils did not match my s14 coil harness. (close but the the pins do not fully engage on the coil so i would not recommend using the oem harness. Get the plugs/pins with your coils to ensure strong connection between the harness and coils.)

[inopsey]

Originally Posted by jr_ss

The SR harness plugs directly into the VQ37 coils. I am not sure about the VR38 coils.

how is the fitment of the VQ37 coils on the valve cover? do you have any pics of how they would mount ?

[jr_ss]

Originally Posted by inopsey

how is the fitment of the VQ37 coils on the valve cover? do you have any pics of how they would mount ?

I?ll try to get some for you later today. Keep in mind this is on a P11 VC and a VET setup, so there are no mounting tabs. I can provide a picture of an S15 VC with these mounted, with and without the PRP bracket. I will say, without securing the coils, the bracket and boots keep these anchored very well.