The everything cd009 swap thread.

[ph1tnessjunk1e]

Originally Posted by BiG MiKE86

Anyone know the thread pitch and bolt length for the 2 bolts that hold the trans mount in place? Thanks


Sent from my iPhone using Tapatalk Pro

Did you find this out? I didn't see a reply.

Originally Posted by BiG MiKE86

Had to pull the engine and bash the shit outta the tunnel for a better fit. Here's the final placement of the shifter.

Looks great!!

I just got the engine (2JZ) and trans (CD009) installed today, however, the engine brackets won't quite sit right on the mounts. Anyways, I think it may be interfering in the trans tunnel, where did you bash?

[BiG MiKE86]

Originally Posted by ph1tnessjunk1e

Did you find this out? I didn't see a reply.







Looks great!!



I just got the engine (2JZ) and trans (CD009) installed today, however, the engine brackets won't quite sit right on the mounts. Anyways, I think it may be interfering in the trans tunnel, where did you bash?

Yeah I don?t remember off the top of my head but I got some hardware from ACE that worked.

Basically bashed along that piece that goes around the tunnel (sheet metal tack welded on) just mash both side and the top flat. Should give you enough clearance. I did install my trans mount to make sure those holes didn?t shift though with all the bashing. Good luck


Sent from my iPhone using Tapatalk Pro

[BiG MiKE86]

Originally Posted by BiG MiKE86

Yeah I don?t remember off the top of my head but I got some hardware from ACE that worked. I think they were M10x1.25

Basically bashed along that piece that goes around the tunnel (sheet metal tack welded on) just mash both side and the top flat. Should give you enough clearance. I did install my trans mount to make sure those holes didn?t shift though with all the bashing. Good luck


Sent from my iPhone using Tapatalk Pro

Sent from my iPhone using Tapatalk Pro