10-25-2011, 07:15 PM | #33 |
Join Date: Mar 2011
Location: Coral Springs, FL
Age: 47
Posts: 16
Trader Rating: (0)
Feedback Score: 0 reviews
|
Its hard to say about the numbers. I am just approximating, as the graph didn't have boost on it. I am just going by what the gauge said.
Also, that was before I figured out the coil pack wires were crossed. May not have been firing fully on that cylinder. |
11-09-2011, 05:21 PM | #41 |
vortech 2003 nissan 350z
in your interested text me at 574-612-5430 looking for a 240 like yours LOL AT THE LAST PIC BUT MY CAR LOOKS GOOD IN IT (my friend posing in front of it lol) |
|
11-10-2011, 04:08 PM | #42 |
Join Date: Mar 2011
Location: Coral Springs, FL
Age: 47
Posts: 16
Trader Rating: (0)
Feedback Score: 0 reviews
|
UPDATE: So it was running really rough the other night. Popping, etc. I found a couple of bare wires in the harness and wrapped them in electrical tape and it drove fine after that. The next morning it cranks over but no ignition.
Now would be the time to make an offer on it as next week it will be getting towed to a shop to have harness pulled and gone through. Would love to unload it now. |
11-20-2011, 01:23 PM | #44 | |
Zilvia Addict
|
Quote:
|
|
12-15-2011, 07:49 AM | #52 |
Join Date: Mar 2011
Location: Forest City NC
Age: 39
Posts: 37
Trader Rating: (0)
Feedback Score: 0 reviews
|
I have an s13 with a 2jz swap installed. We done all the wiring our selves rather than send off, get pre wired, etc... Everything works, fuel pump, injectors, starter, turns over and all that good stuff. Cant get fire on the plugs ! We've switched out coil packs, crank sensor, cam sensors, ingnitor, ecu, plugs, all that good stuff. Still same problem persists, Any one know a good "Shop" or "Person" located in FL that would be good to trouble shoot this problem without charging tons of $$ to fix or attempt to fix ? I'm from NC but working in Port St. Lucie, not far from west palm beach. I am bringing the car down next week when I go home for christmas. I know Titan is in Orlando, Just trying to get it going for cheap as possible. I'm assuming a wire or wiring is not exactly where it needs to be, not hooked up, etc.. Any help would be greatly appreciated ! thanks..
|
Bookmarks |
|
|