Nismo vs SPC Control Arms

[Corbic]

Originally Posted by mav1178

Correct.... but the GKTech rear arms (that work with their HICAS eliminator rear arm) works with both factory rear subframe as well as the HICAS eliminator kit.

So by conventional wisdom, wouldn't the bushing end of the arm be the same width as the S13/R32 rear subframe opening for non-HICAS toe arms?

That's what I was getting at. Eccentric bolt or not, it still offers adjustment on the arm.

That's because you just bolt them onto the factory sub-frame, don't care where the camber-bolt aligns, you just adjust the arm it's self.

Originally Posted by mav1178

OP asked about whether factory has toe adjustment or not, I answered him by pointing out the page in the FSM. Only real solution for the problem is one of the rubber bushing adjustable rear arms, or swap the subframe.

Correct