starting probs

[my240likenoother]

if i run the car for about 20 min turn it off and leave it for about 10 min come back to start it up and it dosnt want to turn over on the first try
so i stop and crank it agen and it fires right up
replace the roter??
replace the wiers??
i replaced the plugs yesterday

[my240likenoother]

i replaced the rotar and the distributor cap and i think that mint of done it

(Edited by my240likenoother at 10<img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/wow.gif" border="0" valign="absmiddle" alt=':0'>3 pm on Aug. 21, 2001)

[my240likenoother]

come on please help me out
today i replaced the wires $90
and the same thing still
HELP ME!!!!!!

[West]

Sounds like my problem sometimes. My starter has been shit for the longest time now. I have one sitting in my garage but I don't want to install it because its a PITA.

My's starter is shot so when I try to turn it over the solenoids don't catch and it wont start cranking the engine, so I have to try to start it a few times then it starts up.

I'd imagine its one of your solenoids on your starter. But don't quote me on that. I will find out for sure once I replace my starter.

[my240likenoother]

ya mark some one sugested that to me but you can tell that it is cranking properly
i dont know ready &nbsp;to flip my lid

[Jeff240sx]

Try hot-wiring to the starter. &nbsp;That will tell you if you have a bad ground. &nbsp;My friend's gf's 200sx had the same problem, and it was a ground wire with a break in it.
-Jeff

(Edited by Jeff240sx at 9:48 pm on Aug. 23, 2001)

[my240likenoother]

sounds a little dangerous but i willl try it