|
Tech Talk Technical Discussion About The Nissan 240SX and Nissan Z Cars |
|
Thread Tools | Display Modes |
03-01-2023, 05:29 PM | #1 |
Post Whore!
Join Date: Oct 2004
Location: San Francisco, CA
Posts: 5,999
Trader Rating: (13)
Feedback Score: 13 reviews
|
Window Regulator Pulley Fix
Hey All,
So S13's window regulator pulleys are all nylon plastic, which kid of sux. As you can see its broken in the upper left hand corner. Usually there is a pulley with a pin through it. To Fix - Dremel through the back side of the rivet and pull out the entire pulley Its roughly a 1/4" hole. Get Part Number 9466T54 - Pulley for Wire Rope Ball Bearing, 3/64" Rope Diameter, 35 lb., 1/4" Shaft Diameter, Nylon 1 - 1/4" round bolt with machined head because you need to be low profile 1 - 1/4" jam nut case you also need low profile 2 - 1/4" round lock washer. (you don't need the washer in the picture....) Bolt through the cable side of the pulley, then behind the pull and the regulator plate, put a lock washer to offset it, then on the other side put lock washer and jam nut with locktite
__________________
Turn and Burn! |
Sponsored Links |
03-02-2023, 10:09 AM | #2 |
Premium Member
Join Date: Jun 2003
Location: torrance, ca
Age: 42
Posts: 12,685
Trader Rating: (130)
Feedback Score: 130 reviews
|
Plus rep for you sir!!!
|
03-02-2023, 10:37 AM | #3 |
Post Whore!
Join Date: Oct 2004
Location: San Francisco, CA
Posts: 5,999
Trader Rating: (13)
Feedback Score: 13 reviews
|
Thanks man.... the motor and track was good, so I thought it'd be a waste of money to through out something could cost me 15 bux to fix.....
__________________
Turn and Burn! |
Bookmarks |
|
|