Link ECU Tech Reference Thread

[slider2828]

Originally Posted by PoorMans180SX

Across the terminals. Pro tip: If using a DTM connector, slide the wires through the seal, crimp the resistor in the terminals with the wires, and then slide everything in the connector housing. All sealed up!

Thanks man... I just saw a video on can bus termination... Just crimp the leads to it... Cool....

I forgot to buy PCB to CAN and CAN Female.... Is that what you need to buy too?

[PoorMans180SX]

Originally Posted by slider2828

Thanks man... I just saw a video on can bus termination... Just crimp the leads to it... Cool....

I forgot to buy PCB to CAN and CAN Female.... Is that what you need to buy too?

I convert their CAN cables to DTM connectors. That way I can just run the length I need to run, and it keeps it neat.
But yeah it looks like there?s a separate plug on the board for their CAN communication, so you?ll need one for that.