Thread: GT2871 USERS. SR motor
View Single Post
Old 07-13-2011, 10:23 PM   #5
codyace
Post Whore!
 
codyace's Avatar
 
Join Date: Dec 2004
Location: Poconos, PA
Age: 40
Posts: 8,030
Trader Rating: (58)
codyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfectioncodyace is close to perfection
Send a message via AIM to codyace
Quote:
Originally Posted by EsChassisLove View Post
Owhat dyno was that on?

And more info
A small dyno jet/non load bearing...it's not very turbo car friendly at all...it doesn't provide realworld load so all turbo cars seem to spool later than they do on street, and don't make the torque they would either...oh well! Can't bitch too much as the dyno is always available to me/us.


My dyno 20psi


Here is a 28RS car with S3 cams, JWT ECU, same dyno (don't mind the top end fall off, stock FWD manifolds suck. 18psi




Here is Matt (sil80wis) car, dyno comparison. 20psi and 10psi

__________________

Want Air Conditioning in your SR20 Swapped car? Check out www.sr20acbrackets.com for more information!

Quest Alternator Conversions for SR20! Check my Group Buy!

Tired of lousy internal gates? Go external wastegate with one of my manifolds, Check out my group buy
codyace is offline   Reply With Quote