Quote:
Originally Posted by BobbyDigi
I will use this technique, i'm going to take my time and make it nice.
What size drill bit would you recommend?
Also, another qustion just for clarification... The only thing holding the support on should be tack welds right?
SO a drill and a bit should/could be the only thing i need to remove it??? right?
|
The tension rod brackets will need to be unbolted. I'd use a 1/2" bit, it's way bigger than you need but the welds don't always drill clean. Take a 5/16" to start them though, then step up. Bring extra batteries, you're drilling a LOT.