Removing s14 Radiator support - HELP

[BobbyDigi]

Originally Posted by projectRDM

There's a few ways to do it, depending on your plans. The entire piece is spot welded, there's a total of about thirty you have to drill out. In between the frame rails there's two on top, two on the side, and two on the bottom. There's a few above the rails on the side, there's three on either top side below the fender on the apron, and there's a line of them below the headlight buckets. The way I remove them to sell is to drill the frame rail and apron welds then just sawzall the rest off, whoever buys it can trim and grind the remaining sheetmetal as needed. You can also just sawzall a few inches behind and cut the entire front clip off, then cut/grind the excess metal off.

I will use this technique, i'm going to take my time and make it nice.

What size drill bit would you recommend?

Also, another qustion just for clarification... The only thing holding the support on should be tack welds right?

SO a drill and a bit should/could be the only thing i need to remove it??? right?